Cast steel anode yoke aluminum slag electrolyte
As a consumable, the cast steel anode yoke and its aluminum guide rod will be exhausted after one month of production in the electrolysis workshop. At this time, it is necessary to remove the old anode components and replace them with new ones. However, aluminum slag and electrolyte will remain on the old guide rod. The cleaning of the electrolyte will also be carried out in the anode assembly workshop.
Cast steel anode yoke protection ring
In addition to removing the electrolyte on the periphery of the cast steel anode yoke, it is also necessary to remove the phosphorus iron ring wrapped around the steel claw. Here, the phosphorus iron ring needs to be pressed off for pressure removal treatment, and finally shot blast cleaned up for recycling.
cast steel anode yoke manufacturing process and production
In addition to recycling, cast steel anode yokes are also professionally produced. Use electric arc furnace and intermediate frequency furnace with rare earth refining to ensure the gas content in the molten steel and ensure the electrical conductivity and strength indicators of its steel claws.
cast steel anode yoke model
generally produces parallel three claws, four claws, three-dimensional four claws, six claws, eight claws, double cast steel anode yokes and other models.
cast steel anode yoke Technical Standard
Cast steel anode yoke is a consumable in the electrolytic aluminum production process, and its consumption level and replacement frequency are generally based on the production limit of the electrolytic workshop. The transfer of the anode assembly can only be operated when the bus bar is lifted and the anode is replaced. Generally, when the anode carbon block is consumed for 15 to 18 days, it is necessary to raise the bus bar once and adjust the anode assembly once.
