Cell Noise and Anode Rod Current Fluctuation

Cell Noise and Anode Rod Current Fluctuation

There are various causes of cell noise in the production process of aluminum electrolytic cells, so the nature of the noise is also different. According to the waveform and frequency classification of the cell noise signal, the cell noise ca...

details
Three repair methods of anode rod

Three repair methods of anode rod

Introduction of three repair methods of anode rod Due to long use time, transportation, open-air stacking and other reasons, all anode guide rods will be bent and corroded to varying degrees, and some anode guide rods also have defects such...

details
Prebaked Anode for low cost electrolytic aluminum

Prebaked Anode for low cost electrolytic aluminum

Introduction of prebaked Anode for low cost electrolytic aluminum In the production process of low-cost electrolytic aluminum prebaked anodes, raw materials such as petroleum coke or powder coke are mainly used, so that the selected binder...

details
Anodized steel jaw for electrolytic aluminum

Anodized steel jaw for electrolytic aluminum

Introduction of anodized steel jaw for electrolytic aluminum Electrolytic aluminum anode steel claw is the connecting component between the anode carbon block and the busbar on the electrolytic cell. During the aluminum electrolysis process...

details
Defects and solutions of extruded magnesium anode

Defects and solutions of extruded magnesium anode

Introduction of defects and solutions of extruded magnesium anode Mg has high specific strength, good shock absorption and electromagnetic shielding properties, and extruded magnesium sacrificial anodes are widely used in the protection of...

details